Envelope Punch Board Gift Box Tutorial

5:04 pm Nupur Priya 0 Comments

Hello friends,
 This is Nupur here from Nupur Creatives & I am sharing a tutorial for a gift box today made using Envelope Punch Board.

20161118_153732

We need 2 pieces of 7" x 7" cardstock. Align all 4 sides of the cardsock at 3 1/2" mark, punch & score. Repeat this with both the pieces.
20161117_210500

Now score all 4 sides of both the pieces at 3/8".
20161117_210940

Cut off the corner squares as shown ( I later cut the corners in a straight line so the edges were 45 degrees to the score line). 
20161117_211217
For the top portion of the box cut off both flaps from one of the sides as shown. This will be the opening of the box.
20161117_211624


Apply tacky tape on the flaps of the bottom piece leaving 2 flaps on one of the triangle pieces. This will be the opening of the box.
20161117_214518

Carefully align and adhere the top & bottom pieces. The picture below shows how it will look like after the box is assembled.
20161117_215213
Make a hole in the top & bottom opening pieces & thread the ribbon through & tie a bow to close the box. Decorate the box with pattern papers & embellishments of your choice.
20161117_220524
Here are few more pix of the decorated gift box... Side view
20161118_153742
& top view...
20161118_153804
Hope you like it...
Thank you for visiting today :)
nupur
Materials Used:
Ephemera Paper Pack

You Might Also Like

0 comments: