Envelope Punch Board Gift Box Tutorial

Hello friends,

 This is Nupur here from Nupur Creatives & I am sharing a tutorial for a gift box today made using Envelope Punch Board.

We need 2 pieces of 7" x 7" cardstock. Align all 4 sides of the cardsock at 3 1/2" mark, punch & score. Repeat this with both the pieces.

Now score all 4 sides of both the pieces at 3/8".

Cut off the corner squares as shown ( I later cut the corners in a straight line so the edges were 45 degrees to the score line). 

For the top portion of the box cut off both flaps from one of the sides as shown. This will be the opening of the box.

Apply tacky tape on the flaps of the bottom piece leaving 2 flaps on one of the triangle pieces. This will be the opening of the box.

Carefully align and adhere the top & bottom pieces. The picture below shows how it will look like after the box is assembled.

Make a hole in the top & bottom opening pieces & thread the ribbon through & tie a bow to close the box. Decorate the box with pattern papers & embellishments of your choice.

Here are few more pix of the decorated gift box... Side view

& top view...

Hope you like it...

Thank you for visiting today :)

Materials Used:
Ephemera Paper Pack